Car Audio

Response Car Amp 4x100WRMS

As a first upgrade amplifier to power full range speakers or a single 4ohm bridged subwoofer the AA-0420 is outstanding value, with up to 80WRMS in stereo or 200WRMS when bridged at 4ohms. Variable high and low pass filters allow you to match this amplifier to virtually any speaker application, with a handy remote subwoofer level controller giving you variable bass control from the front of the car with the twist of a dial.

The AA-0422 is a compact and super affordable 4-channel amplifier that can power and entire sound system. Both pairs of channels offer fully variable high and low pass filters, with path thru RCA pre-outs allowing you to link to additional amplifiers without the additional cost of RCA splitters. This is a great value first upgrade amplifier that would be ideal when matched to the Response coaxials and Venom subwoofer range.

Specifications:
Power / channel @ 4ohm 14.4V: 50WRMS x 4
Power / channel @ 2ohm 14.4V: 80WRMS x 4
Power / bridged @ 4ohm 14.4V: 160WRMS x 2
Signal/Noise ratio: >90dB
Input sensitivity: 200mV to 5V
Low pass filter: 50 - 500Hz @ 12dB/octave
High pass filter: 50 - 500Hz @ 12dB/octave
Pass thru RCA: Yes
Dimensions: 280(L) x 258(W) x 50mm(D)

The AA-0424 supercedes the popular AA-0434 2 x 150WRMS amplifier, but offers even more power output with a massive 500WRMS x 1 when bridged into a 4ohm load – making this ideal for powering two of the new Precision Response dual 4ohm subwoofers in series/parallel wiring. Variable bass EQ of up to 18dB is included, as is a remote level controller to mount on your dash or centre console, while the fully variable high and low pass filters make this amp equally useful for powering subwoofers or full range speaker systems. At $249 this is easily one of the best value 2-channel amplifiers on the market today.

At last, a truly affordable Class-D amplifier that makes absolutely massive power while being able to drive difficult 1ohm loads. The new AA-0428 thunders out over 800WRMS from a compact chassis with an ultra efficient power supply meaning more watts for less strain on your car’s charging system. Tuning your subwoofer’s output has never been easier, with full variable low pass filter, variable subsonic filter, and variable centre frequency bass EQ offering up to 18dB of boost. The input stage will accept a massive 6-volts RMS and the supplied remote level controller lets you vary subwoofer level from the front of the car. This is an ideal amplifier to drive multiple subwoofers wired at 4ohms, 2ohms or even 1ohm, and is a great choice for either sound quality or SPL applications.

Featuring build quality and attributes far surpassing their affordable prices. They feature sturdy and attractive machined cast frames suspending real carbon fibre cones connected via thick rubber roll surrounds, and dual 4ohm voice coils for ideal wiring in pairs or singles to match any of our new amplifier range. Additional features to aid in installation are the integral rubber gasket ring that can be reversed for "basket-out" mounting, and convenient push terminals for both voice coils which will happily accept heavy gauge wiring. Stated power handling is a significant 300WRMS total per woofer (150WRMS per voice coil), and this version is designed for optimum alignment in compact sealed enclosures. It can also be used in low tuned ported applications, with box enclosure designs yielding excellent sound quality
-Thiele Small Parameters (measured with voice coils in parallel)

Featuring build quality and attributes far surpassing their affordable prices. They feature sturdy and attractive machined cast frames suspending real carbon fibre cones connected via thick rubber roll surrounds, and dual 4ohm voice coils for ideal wiring in pairs or singles to match any of our new amplifier range. Additional features to aid in installation are the integral rubber gasket ring that can be reversed for "basket-out" mounting, and convenient push terminals for both voice coils which will happily accept heavy gauge wiring. Stated power handling is a significant 300WRMS total per woofer (150WRMS per voice coil), and this version is designed for optimum alignment in compact sealed enclosures. It can also be used in low tuned ported applications, with box enclosure designs yielding excellent sound quality
-Thiele Small Parameters (measured with voice coils in parallel)

Power Handling: 250WRMS
Impedance: 4ohms (dual voice coil)
Voice Coil Resistance: 1.7ohm
Vas: 26.950Ltr
Qms: 3.788
Qes: 0.452
Qts: 0.404
Sensitivity: 87.105dB/Wm
BL: 9.941 TM
Fo: 38.258Hz
Sd: 346.36 sqCM

Introducing our new range of Kevlar split systems, they are a complete re-vamp of our previous and very popular Kevlar series 6.5-inch component speakers. These units addresses many of the old set’s shortcomings while offering equally as impressive sound quality combined with a dramatic price reduction. The new raw finish Kevlar cones are far stiffer than the old version’s, and also match the new Precision Response coaxials for appearance, while installation is made safer via a protective insert around the woofer’s edge. The tweeters use smooth sounding 25mm soft domes with a compact and easy to use mounting system with flush, angle or surface options. The outboard crossover features high-grade internal components with variable tweeter attenuation for system tuning and polyswitch overload protection. These splits represent a true bargain for those looking for an affordable true sound quality speaker system.

At their incredible prices, these speakers sound every bit as good as sets two and three times their price!

CS-2327
6" Response Precision Kevlar Splits

Power Handling: 60WRMS
Impedance: 4 Ohms
Voice Coil Resistance: 3.4 Ohms
Vas: 11.019
Qms: 4.828
Qes: 0.731
Qts: 0.635
Sensitivity: 88.2dB/Wm
BL: 4.298 TM

The newly updated Precision Response coaxials continue the formula of great sound quality and construction, with the significant update of the cone material to Keclar to match the new high end splits. After trialing other options for tweeter dome material we are satisfied that the titanium swivel dome tweeter that has been carried over is the preferred choice for high frequency transparancy and extension, while still offering a great tonal match to the Kevlar splits as rear fill speakers. The Kevlar cone material also look absolutely fantastic, for a woofer cone material. Each set uses the same high quality 12dB per octave inline high pass filter for the tweeters as before.

The brightest torch we have ever seen! This high intensity discharge (HID) torch is not for the faint hearted, it is so powerful it is capable of illuminating up to a kilometre away! Utilising the same technology used in aftermarket headlights kits for cars, no other torch is capable of such intensity in such a small package. This 24W rechargeable torch  has a burn time over an 100mins and is housed in a very sturdy and weatherproof aluminium casing. It is supplied with a shoulder strap, coloured filters for varying lighting conditions, a 12VDC car and 240VAC mains chargers.

Specifications:
> Dimensions: 72(Dia.) x 380(L)mm
> Battery type: Rechargeable Sony G5 2200mAh lithium-ion x 6
> Light output: 1800 Lumens
> Bulb life: 800hrs
> Run time with full charge: 120mins
> Mains and car charger supplied
> Battery, lanyard and filter lens supplied

This is the BIG BROTHER of Faraday torches! Following the success of the smaller version, we are proud to bring you the 9 inch Faraday torch. No batteries are required for operation. A few shakes up and down will produce a current to run the torch's LED. If the light dims, simply shake the torch again. Whether it is around the house or whilst going camping, this unit will come in handy for those times you need a light in a few "shakes".

* Waterproof & weatherproof
* Floats in water
* Transparent ABS body
* 1 Super Bright LED (Light Emitting Diode)
* No batteries needed
* Size: 235 x 40 mm (dia)

No batteries are required for operation. A few shakes up and down will produce a current to run the torch's LED. If the light dims, simply shake the torch again. Whether it is around the house or whilst going camping, this unit will come in handy for those times you need a light in a few "shakes".
- Waterproof & weatherproof
- Float in water
- Transparent ABS body
- 1 super bright LED (Light Emitting Diode)
- No batteries needed
- Extra Large Size - 295(L) x 52(dia)mm

Stylish in design and packed with features, you won't need to carry anything else. Most watches have limited functionality but not this - it features an Altimeter to measure altitudes up to 29,500 feet, a Barometer to measure pressure, Thermometer to measure in C/F Temperature, Hygrometer to measure humidity, and a digital alarm clock. All displayed in a large LCD Screen.

Altimeter
- Altitude range (-500 to 9000 meters / -1600 to 29500 feet), resolution of 1 meter / 1 feet
- Max / Min memory for altitude
- Altitude history and graphical display of the last 12 hour altitude readings
- Altitude alarm
- Stop watch up to 9hr 59min 59.9 sec
- Altitude total grain or loss 44999 meter / feet

Barometer
- Pressure range 300.0 hPa / mbar to 1100.0 hPa /mbar (8.84 inHg to 32.44 inHg)
- Resolution of 0.1 hPa / mbar (0.01 inHg)
- Max / Min memory for pressure
- Pressure history and graphical display of the last  12 hours pressure readings
- Electronic Pressure Weather Forecast (Sunny, Slightly Cloudy, Cloudy, Rainy, Storm)
- Pressure trend indicators

Thermometer
- Thermometer (-20 degrees to +60 degrees)
- Celsius or Fahrenheit selectable
- Max / Min memory for Thermometer

Hygrometer
- Relative humidity (20% ~ 95%)
- Max / Min memory for relative humidity

Time Keeping
- Time: Hr, Min, Sec
- Calendar: Year, Day of Week, Month, Date, Automatic Calendar
- Alarm : 1 Day Alarm